Screenshot from SpaceX Webcast of the launch of Starlink Group 5-3. I’m smoking cold right now
Mission: SpaceX Falcon 9 - Starlink Group 5-3
Written: February 3, 2023
Third plan from the boss
SpaceX’s Starlink Group 5-3 mission successfully launched 53 Starlink satellites atop a Falcon 9 rocket. The Falcon 9 lifted off from Launch Complex 39A (LC-39A), at the Kennedy Space Center, in Florida, United States.
Starlink Group 5-3 marked the 70th operational Starlink mission and is thought to be a test mission for the evolution of this constellation’s spacecraft: Starlink gen 2.
Because of this, and despite the name, the satellites did not go into the previously filled Starlink Shell 5 — a polar low-Earth circular orbit at 560 km. Instead, the satellites were put into a 43-degree orbit, and will raise their orbits to 530 km.
As mentioned, Starlink Group 5-3 is testing new hardware, involving technologies from SpaceX’s recently acquired internet of things (IoT) company SWARM. It is unknown how these technologies are being tested. In addition to this, the Starlink v1.5 satellites are thought to have been altered with equipment from v2 satellites, no details are known.
These test satellites will pave the way for SpaceX to begin proper Starlink V2 launches, which are scheduled to start in early 2023 on Starlink Group 6-1. Until SpaceX’s Starship launch vehicle is operational, these missions will utilize the Starlink v2 mini satellites.
Starlink Group 5-3 boosted the total number of Starlink satellites launched to 3,875, of which 3,583 are still in orbit around Earth once launched. Starlink Group 5-3 marked the third launch of Group 5 satellites.
The fifth shell of phase 1 of Starlink was supposed to host 172 satellites in another 97.6° inclination in a 560 km low-Earth polar orbit. Shell 5 will consist of four orbital planes with 43 satellites in each plane. This shell doesn't host any Starlink V1.5 satellites.
This altered fifth shell of phase 1 will now host Starlink v2.0 satellites in a 43.0° inclination in a 530 km low-Earth orbit and is currently hosting 163 Starlink v2.0 satellites,
The booster launched from SLC-39A is B1069-5. It landed on the drone ship A Shortfall Of Gravitas, 660 km east of the launch site, roughly eight and half minutes after liftoff.
After boosting the second stage along with its payload towards orbit, the first stage will freefall in a parabolic curve before it performs a 19 second re-entry burn meant to slow the vehicle down before the atmospheric reentry. The booster will then perform a 23 second landing burn and softly land aboard SpaceX’s autonomous spaceport drone ship.
SpaceX will also recover both fairing halves in the Atlantic Ocean with the recovery vessel Bob, named after Demo-2 Astronaut Bob Behnken.
B1069-5 will have made its fifth flight after launching its next mission:
B1069-5 didn’t perform a static fire test on January 25 at 09:30 EST after refurbishment while waiting for an east coast launch out of Cape Canaveral. SpaceX has since Starlink L08 omitted this safety precaution many times so far. It isn’t required to perform a static fire test on inhouse missions like Starlink as to save time.
SpaceX is the first entity ever that recovers and reflies its fairings. After being jettisoned, the two fairing halves will use cold gas thrusters to orientate themselves as they descend through the atmosphere. Once at a lower altitude, they will deploy drogue chutes and parafoils to help them glide down to a soft landing for recovery.
Lately it’s apparent that the fairings are actively being aiming for the droneship in order to speed up the recovery process and cut corners of the time table. The fairing is actively breaking its speed and turning back before deploying its parachute at the last moment. It’s not clear whether or not the cold gas nitrogen thrusters are capable of doing a boost back ‘push’ so the fairings stop their forward momentum mid flight.
Falcon fairings halfs have been recovered and reused since 2019. Improved design changes and overall refurbishment procedures have decreased the effects of water landings and led to an increased recovery rate of fairings.
The fairings are a used pair from six and five previous missions with no known joint mission. Both fairings are expected to survive the landing. Active fairings are equipped with four pushrods to separate the two fairing halfs.
Fairings have evenly spaced venting ports that have been redesigned a number of times by having first ten, then eight and now having their venting ports built as close pairs along the fairing edge. This prevents saltwater from the ocean from flooding and sinking the fairing, and makes refurbishment toward the next flight easier.
The Starlink Grp. 5-3 Payload
In August 2021, SpaceX presented plans to the Federal Communications Commission (FCC) to either use Falcon 9 or Starship to deploy satellites into Starlink Gen 2. But then, in January 2022, the company announced they would use only Starship as they thought it was going to be ready for launches as soon as March of this year.
However, technical delays in readying Starship for its first orbital flight meant that the company had to revisit its plans and in August 2022 it announced to the FCC that they would now launch into Starlink Gen 2 using both Starship and Falcon 9.
The document detailed that “while SpaceX will use technically identical satellites on both rockets, the physical structures will be tailored to meet the physical dimensions of the rockets on which they will be launched.”
This indicated that SpaceX intended to use downsized satellites that would be able to fit inside Falcon 9’s payload fairing. It was then confirmed by Elon Musk during an event with T-Mobile later that month.
The CEO of the company referred to these as Starlink v2 “Mini” but unlike the document, where it doesn’t specify any conditions to launching Starlink v2 satellites on Falcon 9, he said this would only be in the event Starship were to be delayed even further.
Indications that this launch in particular was related to Starlink Gen 2 came in late October 2022 when SpaceX filed a permit with the FCC requesting authorization to communicate with the Falcon 9 rocket during launch and landing for this mission. These permits normally include the landing location of the Falcon 9 booster.
The landing coordinates on the permits for this and subsequent Group 5 missions indicated not only that they intended to use a southeast launch trajectory again just like they did earlier this year, but also that the Group 5 launches wouldn’t be to polar orbit as previously thought.
Starlink’s Gen 1 constellation consists of five orbital shells at four different inclinations. The initial Gen 1 launch campaign to fill the 53.2-degree shell used mission numbers of the form LNN, up to the L28 launch in May of 2021.
In September 2021, SpaceX started using the Group X-Y designation for their Starlink missions. It was understood at that time that the first number, X, would be the shell to which the satellites are being deployed while the second one, Y, indicated the mission number (but not necessarily the order of launch). So far SpaceX has launched missions to three of those shells using “Group X-Y” mission designations.
It was easy then to think that Group 5 launches would be going into the remaining orbital shell which is one with Sun-synchronous orbits – a type of polar orbit.
However, based on the landing coordinates on the FCC permits, it was clear that the Group 5 missions wouldn’t be going into that orbital shell and therefore it had to be related to something new. In particular, these landing coordinates indicated that Group 5 launches were going into a mid-inclination orbit.
The number of satellites flying on Starlink Group 5-3 suggests this mission is flying the F9 satellite configuration which would allow them to use hardware and processes similar to launching Starlink v1.5 satellites under the Gen 1 constellation.
SpaceX has already applied for three more Group 5 launches in the next couple of months and sources indicate they’ll start launching Group 6 missions as early as February, also headed to Starlink’s Gen 2 constellation.
The Falcon 9 Launch
The Falcon 9 countdown for Thursday’s launch followed the 35-minute-long automated propellant load sequence. At T-3 seconds the engine controller sent the ignition command to all nine Merlin 1D engines on the first stage ramped up to full power in 2.8 seconds.
The rocket was then released at T0 by the launch clamps and began its climb into orbit. The first stage for this mission, B1069, flew for the 5th time.
The booster fired its engines for the two-and-a-half minute ascent into near space, after which B1069-5 shut down its engines and separated from the second stage. After separation, it made a landing on SpaceX’s Autonomous Spaceport Drone Ship A Shortfall Of Gravitas which was located 660 km downrange east of The Bahamas.
For this mission, the Falcon 9 launch trajectory went southeast and performed a dogleg maneuver around The Bahamas. SpaceX used similar launch trajectories earlier this year during the winter months to avoid the harsher weather and sea state conditions off the mid-Atlantic coast and is returning to this launch profile for the current winter season.
Falcon 9 launched southeast and performed a dogleg maneuver bending around The Bahamas
After stage separation, the second stage ignited its single Merlin 1D Vacuum (MVacD) engine for approximately six minutes to inject the satellites into LEO.
The fairing halves separated shortly after MVacD ignition and performed a parachute assisted splashdown in the ocean. They will be retrieved from the water by SpaceX’s multi-purpose recovery vessel Bob.
The target insertion orbit for this mission was 325 by 343 km at 43 degrees inclination. The second stage used a single burn of its MVacD engine to put the satellites into the target orbit. Deployment occurred at around T+19 minutes.
Soon after the second stage performs another burn to deorbit and safely burn up over the southwest Indian Ocean.
This mission launched 53 Starlink satellites for the 530 km altitude, 43-degree inclination shell of Starlink’s Gen 2 constellation. This is the third time SpaceX launched a payload to this new constellation and it did so using Falcon 9.
The Falcon 9 rocket
The Falcon 9 Block 5 is SpaceX’s partially reusable two-stage medium-lift launch vehicle. The vehicle consists of a reusable first stage, an expendable second stage, and, when in payload configuration, a pair of 17x34 feet reusable fairing halves.
The Falcon 9 first stage contains 9 Merlin 1D+ sea level engines. Each engine uses an open gas generator cycle and runs on RP-1 and liquid oxygen (LOx). Each engine produces 845 kN of thrust at sea level, with a specific impulse (ISP) of 285 seconds, and 934 kN in a vacuum with an ISP of 313 seconds.
Due to the powerful nature of the engine, and the large amount of them, the Falcon 9 first stage is able to lose an engine right off the pad, or up to two later in flight, and be able to successfully place the payload into orbit.
The Merlin engines are ignited by triethylaluminum and triethylborane (TEA-TEB), which instantaneously burst into flames when mixed in the presence of oxygen. During static fire and launch the TEA-TEB is provided by the ground service equipment.
The Falcon 9 first stage is able to propulsively land, three of the Merlin engines (E1, E5, and E9) contain TEA-TEB canisters to relight for the boost back, reentry, and landing burns.
The Falcon 9 second stage is the only expendable part of the Falcon 9. It contains a singular MVacD engine that produces 992 kN of thrust and an ISP of 348 seconds. The second stage is capable of doing several ignitions - burns, allowing the Falcon 9 to put payloads in several different orbits.
For missions with many burns and/or long coasts between burns, the second stage is able to be equipped with a mission extension package. This package consists of a gray paint strip, which helps keep the RP-1 tank warm, and extra composite overwrapped pressure vessels (COPVs) for pressurization control, and additional TEA-TEB.
No comments:
Post a Comment